Mr. Hembrough Notes

Welcome To Our Page

Notes

Posted: April 6, 2020

Check out these videos on youtube.

         My Tool Pouch-Electrician

         Electrical Safety Awareness For non-electrical workers

         How to Make a Simple Electrical Motor in 5 Minutes

Posted: April 6, 2020

 Check out these videos on YOUTUBE            

               Drilling large Diameter Holes on a lathe

                Chamfering  UCCS Machine Shop

 

Posted: April 6, 2020

  Start with the basics  The videos are great.

Youtube:          Lathe facing and centre drilling

                      Lathe setup  Essential machining skills working with a lathe PART ONE

Posted: April 6, 2020

I hope you all watched the videos? Here's some more to look at!

  Youtube                       Welding PPE for Welding

                                    Top ten welding supplies: The essentials to weld like a pro with eastwood products

Posted: April 5, 2020

   

        Welcome to home Learning 101. Not really. Something to help you keep going. Hope your all doing great, keeping safe and keeping your distance from everybody except at home.  STAY HOME.  WASH YOUR HANDS. This is trying times for everybody. It was great talking to just about every one of you. This is hard. Hard for you. Hard for Me. And remember its hard on your parents too. Help them as much as you can. Say thank you and every night tell them you love them. They will get through this. You will get through this. We'll all get through this.......

                                Call me if you need something, anything, or just want to talk.  Keep safe 

                                 Email is Robert.Hembrough@nbed.nb.ca

Posted: April 5, 2020

This is not what we planned on at the start of the semester..... But we'll do the best we can.
There is some really good You Tube videos out there for people to watch. Here is a few you can look at with a reall good explanation of what we were going to do to finish our hammer.

"Essential machining skills, working with a Lathe Part One"

Then have a look at "Introduction to the Vertical Milling Machine"

Both really descriptive videos to watch

Posted: April 5, 2020

Welcome to Metals Pro 12. Quite different but you should still be able to grasp what has or what should of been done

Have a look at the video on You Tube called "How to Use a Dividing Head"
I watched it and it really explained how to make the wheels and the hubs for your cannon

Any questions give me a call or email me.

Posted: April 5, 2020

  This is not the same as learning in the shop, but because of the cicumstances, we'll have to do the best we can. Check out a few really good You Tube videos 

          "Best 3 way switch explanation ever"

       Then have a look at       "Four way switching explained -How to wire 4 way intermediate light switch"

             Call me if you have any Questions

             Email me at     Robert.Hembrough@nbed.nb.ca      

Posted: April 5, 2020

Welcome to a new way of learning. This is new to me too. Bare with me. As most of you already do, were going to have a some you tube videos which will do some great explaining of what we were going to do before this all happened.
Check a video clip called
How not to Weld: Most common Mig Welding Mistakes
After that look at Secret Profile Pipe. Why do welders not Speak about it