This is not what we planned on at the start of the semester..... But we'll do the best we can.
There is some really good You Tube videos out there for people to watch. Here is a few you can look at with a reall good explanation of what we were going to do to finish our hammer.

"Essential machining skills, working with a Lathe Part One"

Then have a look at "Introduction to the Vertical Milling Machine"

Both really descriptive videos to watch

  This is not the same as learning in the shop, but because of the cicumstances, we'll have to do the best we can. Check out a few really good You Tube videos 

          "Best 3 way switch explanation ever"

       Then have a look at       "Four way switching explained -How to wire 4 way intermediate light switch"

             Call me if you have any Questions

             Email me at     Robert.Hembrough@nbed.nb.ca